To prevent injury, the theaded rod must be cut to length before powering on your lathe. Simply install the drawbar system on your lathe while it is unplugged, then cut the rod with a hacksaw so no more than 2" of rod extends past the collet chuck handwheel. Remove any sharp burrs with a file.
Available exclusively from Craft Supplies USA.
- Low profile design for greater tool access
- Quick and easy to operate
- Most accurate way to drive project mandrels
- Eliminates off-center barrels that look and fit poorly
- Won’t work loose while working
- Steel tightening knob
- Fits No. 2MT lathe spindles
Tightening knob
15-1/4" section of 3/8" dia. threaded rod
1/4" Collet
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Related Items
Recently viewed